HULL TYPE
Semi displacement. EXTERIOR FINISHING
Hull and Freeboards are recently painted.
MATERIAL
Welded aluminum.
ANTI-FOUL
The anti-foul appears recently done.
RUB RAIL
Aluminum rub rails wlded to the freeboards.
PORT LIGHTS
Three port lights to port and starboard.
BULKHEADS
Full aluminum bulkheads.
STRINGERS
4 aluminum stringers welded to the members and outer shell.

TYPE OF KEEL
Full aluminum keel.

PROPS
Four bladed  bronze LH+RH 29D and 25P.
PROP SHAFT
2" stainless steel shafts.

SHAFT SUPPORTS
Welded aluminum struts.
THRU HULLS
Engine intakes, air conditioner intake and generator intake.

ROLL STABILIZERS Naiad Marine hydraulic Roll Control System with two roll stabilizing fins located under the actuators in  the engine compartment. 

RUDDER TYPE
Suspended.
CONSTRUCTION MATERIAL
Stainless steel.

RUDDER POST
Stainless steel.

TRANSOM: Welded aluminum.

SWIM PLATFORM: Hydraulic stainless steel swim platform with painted teak lattes mounted on aluminum welded brackets bolted to the platform with Teflon insulation plates.

LADDERS
Teak staircase from the pilot house and aluminum staircase with teak steps to he helm. COMPANIONWAY
Teak door with tek pop-up hatch.
CANVAS AND SUPPORT STRUCTURE
Bimini top on the helm station.
HARDWARE
Aluminum.
SEATS & BENCHES
Triple bench at the helm and full rear bench on the lower deck.
ARCHES
Bolted aluminum arch with rear hinges.
WOODWORK/JOINERY
Woodwork and joinery was beginning re-finished during the survey.
GUARDRAILS
Welded aluminum guard rails with canvas covering between.

STORAGE: The section under the helm is a large storage compartment with 2 drain holes and aluminum door with teak finishing.

HULL TO DECK JOINT: Welded

DECK: MATERIAL
Welded aluminum on sustainable framework.
EXTERIOR FINISHING
Teak and polymer on the entire deck.
ANCHOR LOCKER
Access on deck hatch. Drainage to free boards.
FRONT & REAR BALCONY
Aluminum welded stanchions and welded panels with teak hardrail around the entire boat.

COMPANIONWAYS: Companionways to port and starboard rails and exterior painted teak sliding doors to the pilothouse.  

COCKPIT: FLOOR
Teak and polymer flooring over aluminum.

 COMPANIONWAY: 6' partition door with painted teak moldings.    

CANVAS AND SUPPORT STRUCTURE
Aluminum hardtop with welded posts. HARDWARE
Aluminum hardware. SEATS & BENCHES
Teak 2 place bench with under stowage.

SUPERSTRUCTURE: MATERIAL
Welded aluminum to the main structure.
WINDOWS/WINDSHIELD
Three forward windshields and wipers at the helm and windows on the port and starboard side. COMPANIONWAY
Teak finished sliding door on the port and starboard side.
SEATS & BENCHES: Captains chair at the helm and rear bench which converts to 2 single berths.

DECK FITTINGS: BOWSPRIT
Aluminum bowsprit fixed to welded brace on the hull. BOW-RAIL
Welded aluminum bow rail with panel and teak finishing. BOW PIPE
Bow pipes on deck with covers.
STANCHIONS: Aluminum stanchions

CLEATS:
8 aluminum cleats.

CHOCKS: 8 Hawse pipes- in front of every cleat

Search light mounted on the superstructure with control at the helm.

CABIN TOP
Painted teak.
FLOORS
Teak and Holley over plywood floors for main salon, master bedroom and pilothouse, carpeting for the forward berth and ceramic tiles in the center head and teak in the forward head.

BULKHEADS
Bulkheads are teak finished plywood.
STORAGE AREAS
Stowage under berths, galley cabinets, wall cabinets, and cubboards.
Teak doors.

Horizontal blinds on the windows.

ACCOMMODATIONS
Forward berth for 2 persons, master bedroom for 2 persons and double bunk in the pilot house.

HEADS
Two heads with sinks.
SHOWERS
1 closed shower cabin. SINKS AND FAUCETS

GALLEY: STOVE TYPE
4 burner volt stove. POWER SOURCE
240 volts through step-up transformer.

MICROWAVE OVEN

BAR B QUE: Nexigrill installed on a post on the swim platform when used.

Maytag 15 cubic feet 120 volt air cooled system.

AIR CONDITIONING/HEATING: Water cooled 120 volts. 4 Cruisair units installed in the engine compartment, 1 WFAH-10 for the master bedroom, 1 WFAH-6 for the pilot- house, 1 WFAH-6 for the guest bedroom and WFAH-16 for the lounge. Electric pump located in the engine room.

TRASH COMPACTER: Kitchen Aid 

ENGINE(S)

ENGINE TYPE - Inboard

MANUFACTURER: Caterpillar C7- 6 Cylinder 460Hp Each ZF Controls

ENGINE(S) Are 2005/ Replaced New in 2009

EXHAUST SYSTEM: Water cooled with fiberglass Center Waterlock and reinforced rubber hosing

COOLING SYSTEM: Fresh and closed water circuits

STRAINERS
Bronze strainers

TRANSMISSION(S): Twin Disc model MG 5061SC
GEAR RATIO 2.43:1. - 2" Stainless Steel Prop Shafts with Aluminum shaft tubes

Fuel Tanks:  3 Aluminum Fuel Tanks/Port and Starboard side in the engine compartment and under the bilge forward of the engine compartment

FUEL POLISHING SYSTEM: ESI fuel polishing system

Batteries: Suretes batteries, two banks of 2X6 volts in series and parallel for inverter charger, windlass reserve, 1X12 volts deep cycle group 31 AGM, Domestic and starting reserve, four 12 volt batteries, deep cycle group 31 and generator starting reserve 2X6 volts in series deep cycle group 24. 

Battery Charger: Mastervolt 12volts 50-3 for house and starting batteries, and Mastervolt 12volts 50-2 for the generator batteries and ProSine 25 amps for the inverter/charger batteries.

SOLAR PANELS: Two Enerwatt of 245 wattts each with TriStar TS-MPPT-60 regulator and TS-RM-2 panel in the pilothouse

Two 50 amps power connections located on the port and starboard side.

120/240 step-up transformer for the galley stove.

ProSine 3.0 of 3000 watts inverter

GENERATOR: 13.5kw Kohler

NAVIGATION EQUIPMENT:

VHF
Standard Horizon Matrix AIS/GPS at the pilot house. The antenna is installed on the port side structure. COMBINATION UNIT
Garmin GMI 10 with GPS.
COMPASS
Danforth Constellation.
RUDDER POSITION
Simrad is-20.
RADAR/GPS/SEA CHARTS UNIT
Fixed unit by Garmin, model GPSmap 7412.
RADAR ANTENNA
The radar antenna is mounted on the radar arch.

FLYBRIDGE NAVIGATION EQUIPMENT:

SPEED LOG
Thomas Walker knot meter. REPEATER
Autohelm Repeater. COMPASS
Danforth compass.

HYDRAULIC AUTO PILOT: Simrad, model AP25 with WR20 remote.

ANCHOR
CQR anchor of 60 pounds located on the bowsprit- 3/8`` chain of, 150 feet approx

Ideal Windlass electric windlass with electric control at the windlass and pilothouse